Carmera Module


For Rearview Camera


Appearance and mechanism design comply with vehicle safety regulations.


186.7°(H) Ultra-wide Angle with zero Dead End can clearly capture surround view of vehicles to ensure drivers' safety.


Output image 1280x720 / 1280x960 (HDR high dynamic range) can cleary capture environmentally outside view of vehicles.


International Protection Marking | IP68/IP69


Through camera modules installed on behind of vehicles, the image is transmitted to Rearview E-mirror.


The biggest advantage of Rearview E-mirror is to eliminate rear obstructions and to show drivers the entire lower blind area.


With same width of mirror, E-mirror shows an image of ultra-wide angle, whose sight width increases about one lane more than traditional rearview mirrors.


360° Around View Monitor is assembled by four wide-angle camera modules installed around the car.  Through these 4 images formed by overlaping and visual view stitched by images, it provides drivers a whole view arround vehicles.


The AVM surround view system with a 360° all-directional image is combined with 2D top view, 3D simulated view, reversing image, etc. functions.  When driving in a narrow alley or mountain road, the driver can see the whole surrounding images to enhance driving safety.


The 360° all-directional view of angle stitched by four-side images can record not only the front accident, but also side and rear images of vehicles.


When sensing turning or reversing, the image will be automatically adjusted the angle of the screen to match the direction of travel and easy know the road condition.


Use the 3D simulation of real car to allow drivers easy to grasp the direction and the distance from surrounding objects.


Most of traffic accidents are caused by "failure to notice situation in front of car", "failure to comity in accordance with regulations", "change lanes or improper direction", etc. resulting in accidents. According to accident data from"Road Transport Bureau, Ministry of Land, Infrastructure and Transport", 60% caused by "rear collision”, 20% caused by "side collision" and only 10% caused by "front collision" are shown.  Comparing to dual camera modules installed in front view and rearview, this 360° Around View Monitor System can avoid blind spot and reduce the risk of accidents. 


Besides of driving accidents, there are many tragic cases in society where children are accidentally run over by cars due to blind corners. When each driver can confirm that there are no children around through 360° surround images before driving, it can greatly reduce accident rate.


Different from past installation within 1 ~ 2 days, now using a Chart to position and stitch images can shorten 0.5 ~ 1 day of working hours to greatly save time.


FOV 231.4°(D) , 186.7°(H) , 136.8°(V)
F no F2.0
Lens Composition G+P
Sensor Specification OmniVision,1/3.55" CMOS_HDR
Sensor Dynamic range 120dB
Output Resolution 1280 x 960
Frame Rate 30fps
Output Format HD-TVI
Power Input 5V
Power Consumption 875mW(5V/175mA)
Dimensions 26 x 26 mm
Operating Temperature -30°C~85°C
Storage Temperature -40℃~85℃

Film Share

Back to list
Inquiry Inquiry